Chimney coated with elastomeric sealant

  1. 1
    Coating the upper metal chimney stack

    As you can see we coated all the metal from the first overlap to the very bottom of the metal flange.

    Go To Pin
  2. 2
    Lower chimney flange coated in Aldo

    We put the Aldo 385 on the lower flange as well and we coated it in a very thick layer all the way to the edge of the metal where the metal roof trim meets covers the flange.

    Go To Pin
  3. 3
    Clear sealant at roof to chimney transition

    We used the clear in this section just in case it was at all visible from the ground. It wouldn’t be as much of an eyesore. Plus we also filled that area is so thick that it created a flat area for the water to run off easier.

    Go To Pin
  4. 4
    Sealing up screws that were backing out

    There was a small handful of screws that were backing out it starting to back out. So we ran the screws back in the metal and used clear roofing sealant to go over the heads of the screw

    Go To Pin

Visual Marketing By Lead Symphony – Patent Pending

Litespeed Construction Knoxville