Sevierville TN cabin with chimney issues.

As you can see we coated all the metal from the first overlap to the very bottom of the metal flange.

We put the Aldo 385 on the lower flange as well and we coated it in a very thick layer all the way to the edge of the metal where the metal roof trim meets covers the flange.

We used the clear in this section just in case it was at all visible from the ground. It wouldn’t be as much of an eyesore. Plus we also filled that area is so thick that it created a flat area for the water to run off easier.

There was a small handful of screws that were backing out it starting to back out. So we ran the screws back in the metal and used clear roofing sealant to go over the heads of the screw

As you can see I have added arrows in the photos that point to areas where water can easily get under the metal and into the roof.

This is an area that is notorious for leaking. Where the roof butts up to the chimney. During heavy downpours, the water can back up in this small area and backflow under the metal. This usually will only happen during very heavy rain. As you can see somebody has already used a Clear Sealant along some of the edges but it’s beginning to crack due to age or a Cheap product.

I’m these pictures I have put arrows and short descriptions as well. There are many areas where water could make it under the metal.