Standing Seam Metal Roof Repair. There are several places where this metal roof is having problems. This is the original metal roof installed 20 years ago.
So the repairs at Litespeed construction will be replacing one piece of ridge cap that was blown off—adding a new transition flashing.
Sealed Up All Cracks
- 1Sealed All Cracks
We resealed all spots that had old caulking. We also sealed any cracks that could possibly be the culprit of leaks.
Go To Pin
Transition Flashing Sealed
- 1Transition Flashing That Was Covered
Added a new piece of metal about 20 feet long to cover transition flashing and sealed. Used gasket screws to prevent leaks. This will ensure that water runs off instead of running back and into the home.
Go To Pin
Sealed Ridge Cap
- 1Added New Metal To Ridge Cap
Added new metal to 2 ridge caps that were exposed. This will preven water from running down inside
Go To Pin - 2Attached Ridge Cap
Used gasket screws to prevent leaks from holes.
Go To Pin
Sealed Up Dormer
- 1Sealed Siding
We sealed up where the siding meets the metal to prevent any water from getting through there.
Go To Pin - 2Sealed Dormer
We sealed up the front portion of the siding to prevent any water that runs off from getting into the home.
Go To Pin
This is a piece of transition flashing that we need to flash over there is problems here
Table of contents
- We are going to add new metal flashing at this metal roof transition
- This is the dormer that we need to caulk the window and the flashing
- 1We are going to add new metal flashing at this metal roof transition
This transition is pulling up and we will need to replace this to prevent this roof from leaking.
Go To Pin - 2This is the dormer that we need to caulk the window and the flashingGo To Pin
This dormer needs to be caulked in the front and up the sides
- 1This flashing needs to be caulked and so does the front of the Dormer
This metal roof has a couple of different locations that need to be caulked this is one of the main ones. And we also need to caulk the front window on the dormer as well.
Go To Pin
This is a piece of transition flashing that needs to get covered to prevent roof leaks
- 1This transition flashing needs to be covered there’s Rotten wood here
So this panel of Metal has to be covered to prevent roof leaks this is not all the way across the section of the roof this is near Valley and this one piece of the panel did not come all the way up to the transition flashing. This can definitely cause roof leaks and we will need to cover this while we are repairing this roof.
Go To Pin
A piece of ridge cap needing to be replaced
- 1This is a piece of metal ridge cap that needs to be replaced
This is a piece of metal ridge cap that needs to be replaced. If this metal ridge cap is not replaced, it could leak into this metal roof and cause problems for this customer.
Go To Pin